Janisol Door System

Janisol door
WK1 / WK2 / WK3 (make a selection) in accordance with DIN EN 1627
Thermally insulated steel profile system for doors with a basic depth of 60 mm

Design features:
The load-bearing construction consists of thermally broken steel profiles with integrated isolators
(tested pre-rolled).
All corner and T-joints are securely welded together.
The high-quality insulating bar securely joins the half profiles together. It withstands the short-term temperature increases during welding.
Smooth steel profiles and insulating bars must be used on all sides.
In the case of door units with burglar-resistant requirements, the fabrication and assembly guidelines from the system provider must be observed.
The width of the profiles (without rebates) is 25/50 mm
Door leaves flush-fitted inside and outside with 5 mm shadow gap on all sides.
Double, continuous rebate weatherstrip on three sides. Transition to automatic floor seal without using special seals
Please select the required threshold construction and delete alternatives.
Without a threshold, no seal.
With aluminium semi-circular profile and weatherstrip.
Without a threshold, with automatic floor seals.
With threshold rebate (allow for height difference in the floor)
End of threshold construction selection
All corner and T-joints are securely welded together
The doors are designed to be burglar resistant (WK1 / WK2 / WK3) in accordance with DIN ENV 1627. Only tested fittings that belong to the system may be used (type and method of construction are described in more detail in the “Fittings” section).
The use of glazing in accordance with DIN EN 356 and/or infills as gypsum plaster board panels with sheet steel panelling is tested and approved (type and design are described in more detail in the section on glazing and infills)
The installation and fabrication guidelines from the system provider must be observed.
The infill is sealed in using double-sided tape and sealing is by means of permanently elastic sealing compound.
A glazing bead is used on one side of the glazing.
Glazing bead: ???
Wider sill rails or transoms are possible through the use of profile combinations in conjunction with flush-fitted, welded steel inserts. For sill rails over 100 mm, the sill rail sheets must be 3 mm thick.

Profile depths:
Outer frame, mullion, transom 60 mm
Leaf frame (door) 60 mm

Profile face widths:
Outer frame (door) 40/65/87.5 mm
Z trim (door) 40 mm
Outer frame (glazing) 47.5/72.5/95 mm
Sill rail profile (glazing) 47.5/70/95 mm
Outer frame extension 25/50 mm
Mullion 70/95 mm
Transom 70/95 mm
Leaf frame (door) 65 mm
Sill rail profile (door) 70/95 mm

download